We at Esthetrix are dedicated to the purpose of making the practice of dentistry easier and affordable. Through our years of hands on experience in dental practice, we are perfectly familiar with the challenges in dentistry and are committed to making it a very enjoyable experience for dentists.
The new 3M™ ESPE™ (Soft) Monophase Polyether Impression Material with its bright colour means enhanced readability for you.
MICROETCHER is a compact, fully auto clavable micro-blaster for use with abrasives such as aluminum and silicon oxide powder (particle size 20-50 micron). The micro-fine blasting can be used to roughen the surfaces of metal, ceramic, and plastic materials for effective reinforcement of adhesion with bonding agents.
Esthetrix LED Curing Light
Content
Esthetrix - MicroetcherUnboxing Esthetrix Microetcher:Esthetrix Microetcher Vs Blaster:
MICROETCHER is a compact, fully auto-clavable micro-blaster for use with abrasives such as aluminum and silicon oxide powder (particle size 20-50 micron). The micro-fine blasting can be used to roughen the surfaces of metal, ceramic, and plastic materials for effective reinforcement of adhesion with bonding agents.
Only 0.5mm sandblasting hole, improve the precision and accuracy of sandblasting and sand powder to extend the use of me, improve the accuracy. Built-in a suction system to prevent the risk of damage to air compressor by sand powder.
USES:
1) MICROETCHER is used to prepare, clean, and coat (silicatize) the surface prior to cementation of e.g. crown, bridges, inlays, onlays, orthodontic fastenings.
2) MICROETCHER Indirect metal restorations, composite or ceramic restorations orthodontic bands and brackets.
3) To remove cement prior to re cementation.
4) Formate finish blasting to check the fit of cast metal restorations (non-fitting areas become visible.
5) Sandblast Zirconia crowns before cementing and try in 6) Micro-roughening prior to adhesive repairs of composite and porcelain 7) Micro etching enamel before bonding 8) Micro etch immediate dental sealed (IDS) surface.
[pdf-embedder url="https://wordpress-854801-3055602.cloudwaysapps.com/wp-content/uploads/2020/09/Microetcher-2.pdf" title="Microetcher (2)"]
Esthetrix Light Cure:
3 modes - Standard, Ramp & Pulse
Output independent of chargin
upto 500 mes of 10 sec. cure
2 output funcons - 180mW/cm² & 1200mW/cm²
Two modes:
(P₂) Standard mode - for composite resins
(1000-11200 MW/cm²)
(P1) Ramp mode - for orthodontics,
cementation (1600-1800 mw/cm²)
Uniform intensity irrespective of battery life
Lightweight and cordless
One full charge can give up to 500 times of 10 sec. cure
